McKesson Heat and Moisture Exchanger 28.8 mg H2O / L @ VT 500 mL 0.72 cm H20 @ 30 LPM, 50/CS

Heat and Moisture Exchanger 28.8 mg H2O / L @ VT 500 mL 0.72 cm H20 @ 30 LPM, 50/CS

This heat and moisture exchanger is a mini in-line humidification device with a CO2 port for breathing systems. It fits short-term airway humidification needs in ventilator or anesthesia circuit workflows where buyers want moisture retention, low breathing resistance, and convenient gas sampling access. The mini design supports tidal volumes from 150 mL to 1000 mL, with 28.8 mg H2O/L moisture output at VT 500 mL and 0.72 cm H20 resistance at 30 LPM.

Good Fit For

• Short-term airway humidification in ventilator circuits
• Anesthesia circuit setups that need heat and moisture retention
• Respiratory workflows that require end tidal CO2 sampling access
• Single-patient disposable use

Key Features

• Mini in-line heat and moisture exchanger supports tidal volumes from 150 mL to 1000 mL for broad use among children and adults
• CO2 gas sampling port gives convenient access to airway gases during respiratory care workflows
• High moisture retention helps return heat and moisture to the patient during short-term airway humidification
• Low airflow resistance of 0.72 cm H20 at 30 LPM helps minimize work of breathing
• Clear housing makes it easier to view humidification levels during use
• ISO-standard connections and luer sampling ports support secure, leak-resistant attachment

Applications and Usage

• Adding humidification to a ventilator breathing system
• Using in an anesthesia circuit where compact in-line setup is preferred
• Sampling airway gases through the end tidal CO2 port
• Supporting short-term breathing circuit humidification for patients within the stated tidal volume range

Packaging and Handling

• Packaging: CS.
• Size: 0.72 cm.
• Sterility: Sterile.
• This product is marked not sterile.
• The mini format is intended for tidal volumes from 150 mL to 1000 mL.
• Connections are 22 mm O.D. / 15 mm I.D. x 22 mm I.D. / 15 mm O.D. Port, so buyers should confirm fit with their breathing system.
• Each unit is individually wrapped for single patient use.

FAQ

• What kind of respiratory setup is this heat and moisture exchanger used with? This heat and moisture exchanger is intended for breathing systems such as ventilators and anesthesia circuits.
• Does this model include a CO2 sampling port? Yes. The exchanger has an end tidal CO2 sampling port with luer gas sampling ports for secure connection.
• What tidal volume range does the mini design support? The mini design supports tidal volumes from 150 mL to 1000 mL.
• Is this heat and moisture exchanger sterile? No. The product is marked non-sterile.
• Is natural rubber latex used in this product? No. The product is not made with natural rubber latex.

From McKesson.